
Installing the Evaluation Daughtercard
Part Number 140-00192-100
As discussed in the previous section, GPIOs 3 through 8 are set by default for special functions such as
modem controls. To use GPIOs 3 through 8 as normal GPIOs, you must place a jumper between JP7
and JP8 for the specific GPIO as described in the previous section. GPIO 2 can also have a special
function if SPI mode is selected for the LCD display via header JP12 as described in the LCD Interface
section later in this chapter.
Table 10 General Purpose I/O Signal Descriptions
Special function SPI_CS- for LCD display
Special function TEMP_CS SPI temperature sensor enable
Special function, nLED_3; wired link
Special function, nLED_2; wireless link
Switch Input; 1 = off, 0 = switch depressed*
*The functionality of GPIO_9 and GPIO_10 cannot be changed by the user.
LEDs and General Purpose I/O Signals
The LEDs are connected to the 10 GPIOs for easy viewing of signal activity. The first 7 GPIOs drive the
first 7 LEDs, D1 to D7 (these LEDs indicate the status of the GPIOs). GPIOs 7 to 9 drive LEDs D8 to
D10. Logic 0 and 0 volts on GPIO_x illuminates the LED.
Table 11 LED and GPIO Descriptions
Comentários a estes Manuais